Free independent sizing calculator · No signup required
PowerMatch
BATTERY RUNTIME EXPLAINED

How long will a 1,000Wh power station last?

A quick answer: a constant 100W AC device might run for roughly 8.5 hours from a fully charged 1,000Wh battery, using an illustrative 85% conversion efficiency. Your actual result will vary.

Updated November 19, 2026 · Independent educational estimate · No products hands-on tested

The key difference: 1,000 watt-hours (Wh) describes stored energy, while watts (W) describes how quickly an appliance uses power. Divide usable watt-hours by average watts to estimate operating time. AC inverters consume some energy, so the headline battery capacity is not the same as electricity delivered to your appliance.

FREE INTERACTIVE ESTIMATOR

Try your own appliance

Enter a battery size and the power your connected devices actually draw. Results update automatically.

Example: 1,000Wh battery, fully charged
Use measured average watts when possible
Actual efficiency varies by model and load
Try a load:
Estimated continuous AC runtime
8.5 hours

About 8 hours 30 minutes · estimated usable energy: 850 Wh

1,000 Wh × 85% ÷ 100 W

Planning estimate, not a guaranteed result. The calculation assumes a full charge, steady load, and no recharging. It does not separately model AC standby consumption, battery reserve, aging, temperature, surge power, or appliance duty cycles. Very low-power loads can have much shorter runtime than this simple calculation implies.

Examples: what can a 1,000Wh battery run?

These examples use a hypothetical 1,000Wh battery and 85% assumed AC efficiency, so they have 850Wh of estimated usable energy. They are math examples, not product tests, and each assumes one constant load.

Constant AC loadEstimated runtimeExample type of use
10W85 hoursSmall light (standby losses may dominate)
50W17 hoursLow-power electronics
100W8.5 hoursSmall TV or similar measured draw
200W4.25 hoursSeveral devices together
500W1.7 hoursModerate continuous appliance load
1,000W0.85 hours (51 minutes)High continuous load, if inverter supports it

Why a refrigerator is different

Refrigerators don't necessarily draw the same watts continuously. A compressor turns on and off, and the startup surge may be far higher than the running wattage. A label saying “120W” is not the same as a measured 24-hour average of 120W. To estimate refrigerator runtime more reliably, measure total watt-hours over a realistic period with a compatible energy meter, then account for startup power separately.

Example: If a refrigerator actually averages 50W over its full on/off cycle, a 1,000Wh station at an assumed 85% AC efficiency gives 850 ÷ 50 = 17 hours before additional standby losses or other factors. That's not a promise for any particular fridge.

Four things that change runtime

  1. Conversion losses: AC outlets require an inverter. USB or DC output may use a different amount of energy.
  2. Actual load: A laptop charger rated for 65W will not always draw 65W. A heater or cooking appliance may draw much more than a small electronic device.
  3. Surge and output limits: A power station must be able to start and run the appliance; battery capacity alone cannot tell you that.
  4. Environment and standby draw: Cold, heat, battery age, and leaving the inverter enabled can all change actual runtime.

How to choose a power station for your needs

Start with the PowerMatch multi-device calculator, which estimates how much capacity you need across several devices and days without charging. Then visit our manufacturer specification comparison to check battery capacity and continuous AC output against the result. Our calculations and comparisons are educational; verify the model's official specifications before buying.

Method and source

Our runtime math uses rated Wh × assumed AC efficiency ÷ average AC watts. This is consistent with the approach described by Generac's power-station runtime guide ↗, which explains inverter losses and why actual runtime depends on load and conditions. We use 85% only as an illustrative assumption, not as a tested efficiency for any specific brand. We have not performed independent battery or appliance measurements.

Affiliate disclosure: This page currently contains no commission-earning shopping links. PowerMatch is approved for Jackery US, but its Awin tracking link is currently inactive. If we add a working affiliate link, we'll clearly identify it where it appears.

Calculate my full setup ↗